MS-WEDM ( Medium Speed wire EDM ) Dielectric Fluid X-618 is suitable for CNC wire-cut EDM machines, reusable wirecut machines, and molybdenum wire-cut machines with excellent rust prevention, lubrication, cooling, and cleaning properties. Easy to use, store, and transport, is the first choice of Wire EDM shops.

Advantages：

• Efficient                          High cutting efficiency with large thickness without fringe, 20% faster than emulsified oil.
• Excellent Surface       High surface finish, 30% better than emulsified oil processing.
• Clean                                There is no black sticky attachment on the cutting surface and do not need solvent oil to clean. Easy to release the workpiece.
• Low foam                       Easy visual operation.
• Long life                         Low silk consumption, save processing cost for you.
• Safe                                   Free of restricted chemicals, and non-toxic.
• Anti-rust                        Good rust protection properties for black and non-ferrous material.

Attention:

Before first use, please follow the instruction.

• Please add the original liquid and water in proportion when filling the liquid. While mixing, dilute in a ratio of 1 part fluid to 5.5 parts water. Ordinary tap water can be used to mix with the working fluid. Don’t use well water, hard water, unclean water, or other mixture. Purified water is recommended.

• Please use a magnet to hold the workpiece before processing to avoid falling and breaking the molybdenum wire.
• The original cutting fluid and solution should be poured clean and thoroughly clean into the water tank, first rinse with water, and then prepare a certain concentration ratio of cutting fluid solution.
• Please add new fluid to the tank. Make sure to use the mixed fluid when the water levels fall, just keep the concentration stays at 11%-12%. Ensure that the replacement is the same type of cutting fluid, and can not be replaced at will.
• When working for a long time, please replace the new fluid in time. This can guarantee machining precision.
  If installing a filterable water-cycling system or filter in the work table and water tank inlet, the working fluid will be much cleaner and the useful life will be longer.